Pico Technology have launched their latest 5 GHz SXRTO Sampler Extended Real Time Oscilloscope, but what is SXRTO. Learn more about the benefits and cost savings compared to Real Time Oscilloscopes, RTO below.

The real-time oscilloscope
Real-time oscilloscopes (RTOs) are designed with a high enough sampling rate to capture a transient, non-repetitive signal with the instrument’s specified analogue bandwidth. According to Nyquist’s sampling theorem, for accurate capture and display of the signal the scope’s sampling rate must be at least twice the signal bandwidth. Typical high-bandwidth RTOs exceed this sampling rate by perhaps a factor of two, achieving up to four samples per cycle, or three samples in a minimum-width impulse.

Equivalent-time sampling
For signals close to or above the RTO’s Nyquist limit, many RTOs can switch to a mode called equivalent-time sampling (ETS). In this mode the scope collects as many samples as it can for each of many trigger events, each trigger contributing more and more samples and detail in a reconstructed waveform. Critical to alignment of these samples is a separate and precise measurement of time between each trigger and the next occurring sample clock.
After a large number of trigger events the scope has enough samples to display the waveform with the desired time resolution. This is called the effective sampling resolution (the inverse of the effective sampling rate), which is many times higher than is possible in real-time (non-ETS) mode.
As this technique relies on a random relationship between trigger events and the sampling clock, it is more correctly called random equivalent-time sampling (or sometimes random interleaved sampling, RIS). It can only be used for repetitive signals – those that vary little from one trigger event to the next.

The sampler-extended real-time oscilloscope (SXRTO)
The PicoScope 9404 SXRTO has a maximum effective sampling rate in ETS of 1 TS/s. This corresponds to a timing resolution of 1ps, 2000 times higher than its actual maximum sampling rate.
The PicoScope 9404-05 SXRTO has an analogue bandwidth of 5 GHz. This means that it requires a sampling rate of at least 10 GS/s, but for an accurate reconstruction of wave shape, we need far higher than this. The PicoScope 9404 gives us 200 sample points in a single cycle at 5 GHz and 140 points in a minimum-width impulse.

So is the SXRTO a sampling scope?
All this talk of sampling rates and sampling modes may suggest that the SXRTO is a type of sampling scope, but this is not the case. The name sampling scope, by convention, refers to a different kind of instrument. A sampling scope uses a programmable delay generator to take samples at regular intervals after each trigger event. The technique is called sequential equivalent-time sampling and is the principle behind the PicoScope 9300 Series sampling scopes. These scopes can achieve very high effective sampling rates but have two main drawbacks: they cannot capture data before the trigger event, and they require a separate trigger signal – either from an external source or from a built-in clock-recovery module.
We’ve compiled a table to show the differences between the types of scopes mentioned on this page. The example products are all compact, 4-channel, USB PicoScopes.

*Higher-bandwidth real-time oscilloscopes are available from other manufacturers.
**These functions are possible at low sampling rates, up to 1 MS/s.

Click HERE for further information, application support, demo or quotation requests  please contact us on 01582 764334 or click  to email.

Lambda Photometrics is a leading UK Distributor of Characterisation, Measurement and Analysis solutions with particular expertise in Electronic/Scientific and Analytical Instrumentation, Laser and Light based products, Optics, Electro-optic Testing, Spectroscopy, Machine Vision, Optical Metrology, Fibre Optics and Microscopy.