Home Time & Frequency Standards Frequency Standards/Oscillators SRS PRBB Breakout Connector Interface Board for PRS10

SRS PRBB Breakout Connector Interface Board for PRS10

Availability: Awaiting stock
Please contact us for estimated delivery


Product Code:
14966
Manufacturer: Stanford Research Systems
Special Price £150.35 £180.42 Regular Price £186.00
PRBB Breakout Connector Interface Board for PRS10

More info and finance questions

Lambda Exclusive Promotion:
Additional 12 months warranty for free (2 years total) via our UK Service Centre.

This board is not part of the standard product and is available from the factory at and additional charge. It is intended to facilitate customer evaluation of the product by adapting the standard product’s interface connector to connector types which are more readily available in the laboratory (such as BNCs and DB9 for RS-232).

This board connects to the outside of the unit. Three BNCs are used to source 10MHz and the 1PPS outputs, and to receive the 1PPS input. A DB9(female) allows direct connection to a computer (usually via COM2:). A 2.1mm power connector allows the unit to be connected to a standard +24V/2.5A power supply (centre conductor must be positive).

The 10MHz output should be terminated into a 50Ω load. The output will be about 0.5Vrms (about 1.41Vpp).

The RS-232 interface uses CMOS logic levels (0V and +5V) which will work with standard RS-232 line drivers and receivers. The +12V of the standard RS-232 line driver will not harm the logic input, and the +5V RS-232 output from the rubidium standard will work with virtually all computers, provided the cable is less than 25 feet long. The RS-232 control lines, CD, DSR and CTS are all pulled high via 10kΩ resistors. An XON/XOFF protocol is used to pause communications as needed. The LOCK/1PPS function may be configured via RS-232. The factory default is a low level to indicate lock, with a 10ìs pulse to +5V at 1PPS, with the leading edge being defined as the 1PPS timing reference. This BNC output is a CMOS logic output via a 1kΩ resistor. LEDs are used to indicate +24V power (electronics and heaters), lock status, and RS-232 data received and RS-232 data transmitted.

Write Your Own Review
You're reviewing:SRS PRBB Breakout Connector Interface Board for PRS10
Your Rating
Photo Product SKU
SRS FS710 7 Channel Distribution Amplifier SRS FS710 7 Channel Distribution Amplifier - >
SRS FS725 Benchtop Rubidium Frequency Standard SRS FS725 Benchtop Rubidium Frequency Standard - >
SRS PERF10 Rubidium Audio Clock SRS PERF10 Rubidium Audio Clock - >
SRS PRS10 Rubidium Frequency Standard SRS PRS10 Rubidium Frequency Standard - >
SRS SC10 10 MHz High Stability Ovenized Quartz Oscillator SRS SC10 10 MHz High Stability Ovenized Quartz Oscillator - >
SRS FS740 - GPS Time and Frequency System SRS FS740 - GPS Time and Frequency System - >
SRS FS752 - GPS Disciplined Oscillator SRS FS752 - GPS Disciplined Oscillator - >
SRS O740ANT1 Indoor GPS/GNSS Antenna for FS740 FS752 SRS O740ANT1 Indoor GPS/GNSS Antenna for FS740 FS752 - >
SRS O740ANT2 Outdoor GPS/GNSS Antenna Kit for FS740 FS752 SRS O740ANT2 Outdoor GPS/GNSS Antenna Kit for FS740 FS752 - >